Installing An Lpu With Standard Ejector Levers; Installing An Lpu With Foldable Ejector Levers - H3C S12501X-AF Quick Start Manual

Installing an LPU with standard ejector levers

1. Orient the LPU with the upside up based on the orientation of the lettering on the LPU.
2. As shown by callout 1 in
supporting its bottom with the other, gently slide the LPU into the slot along the slide rails.
Keep the LPU parallel to the slot to avoid damaging other components in the chassis.
3. As shown by callout 2 in
the LPU is inserted into the slot.
4. As shown by callout 3 in
until you cannot move it.
5. As shown by callout 4 in
contact with the panel.
6. As shown by callout 5 in
Figure 8 Installing an LPU with standard ejector levers
(1) Push the LPU slowly along the slide rails into the slot
(3) Push the LPU by the middle part on the front panel
(5) Fasten the captive screws on the LPU

Installing an LPU with foldable ejector levers

1. Orient the LPU with the upside up based on the orientation of the lettering on the LPU.
2. As shown by callout 1 in
supporting its bottom with the other, gently slide the LPU into the slot along the slide rails.
Keep the LPU parallel to the slot to avoid damaging other components in the chassis.
Figure 8, holding the LPU by the front panel with one hand and
Figure 8, rotate the ejector levers outward to the outmost when most of
Figure 8, continue to push the LPU by its middle part on the front panel
Figure 8, push the ejector levers inward until they come in close
Figure 8, fasten the captive screws to secure the LPU to the slot.
Figure 9, holding the LPU by the front panel with one hand and
9
(2) Rotate the ejector levers outward
(4) Push the ejector levers inward