Advertisement
iTEMP TMT182B
Endress+Hauser
3
Incoming acceptance and product
identification
1. Unpack the temperature transmitter carefully. Is the packaging or content free from
damage?
Damaged components must not be installed as the manufacturer can otherwise
not guarantee compliance with the original safety requirements or the material
resistance, and can therefore not be held responsible for any resulting damage.
2. Is the delivery complete or is anything missing? Check the scope of delivery against
your order.
3. Does the nameplate match the ordering information on the delivery note?
4. Are the technical documentation and all other necessary documents provided? If
applicable: are the Safety Instructions (e.g. XA) for hazardous areas provided?
If one of these conditions is not satisfied, contact your Endress+Hauser Sales Center.
3.1
Product identification
The following options are available for the identification of the device:
• Nameplate specifications
• Extended order code with breakdown of the device features on the delivery note
• Enter the serial number from the nameplate in the W@M Device Viewer
(www.endress.com/deviceviewer): All data relating to the device and an overview of the
Technical Documentation supplied with the device are displayed.
• Enter the serial number on the nameplate into the Endress+Hauser Operations App or
scan the 2-D matrix code (QR code) on the nameplate with the Endress+Hauser
Operations App: all the information about the device and the technical documentation
pertaining to the device is displayed.
3.1.1
Nameplate
The right device?
Compare and check the information on the nameplate of the device against the
requirements of the measuring point.
Information on the nameplate:
• Serial number, device revision, firmware version and hardware version
• Data Matrix 2D code
• 2 lines for the TAG name and extended order code
• Approval in hazardous area with number of the relevant Ex documentation (XA...)
• Approvals with symbols
3.1.2
Name and address of manufacturer
Name of manufacturer:
Address of manufacturer:
Incoming acceptance and product identification
Endress+Hauser Wetzer GmbH + Co. KG
Obere Wank 1, D-87484 Nesselwang or
www.endress.com
7
Advertisement
