Advertisement
Mounting
10
A
Mounting in a terminal head (terminal head flat face as per DIN 43729)
4
Connection wires
5
Head transmitter
6
Mounting springs
7
Mounting screws
8
Terminal head cover
9
Cable entry
Procedure for mounting in a terminal head, item A:
1. Open the terminal head cover (8) on the terminal head.
2. Guide the connection wires (4) of the insert (3) through the center hole in the head
transmitter (5).
3. Fit the mounting springs (6) on the mounting screws (7).
4. Guide the mounting screws (7) through the side boreholes of the head transmitter
and the insert (3). Fix both mounting screws with the snap rings (2).
5. Tighten the head transmitter (5) along with the insert (3) in the terminal head.
6. After wiring , close the terminal head cover (8) tightly again.
B
Mounting on DIN rail (DIN rail as per IEC 60715)
1
Mounting screws
2
Head transmitter
3
Snap rings
4
DIN rail clip
5
DIN rail
Procedure for mounting on a DIN rail, item B:
1. Press the DIN rail clip (4) onto the DIN rail (5) until it engages with a click.
2. Guide the mounting screws (1) through the side boreholes of the head transmitter
(2). Then fix both mounting screws with the snap rings (3).
3. Screw the head transmitter (2) onto the DIN rail clip (4).
4.2.1
Mounting typical of North America
1
2
Head transmitter mounting
1
Thermowell
2
Insert
3
Adapter, coupling
4
Terminal head
5
Head transmitter
6
Mounting screws
2
3
4
iTEMP TMT182B
5
6
A0008520
Endress+Hauser
Advertisement
