I) Connecting An Air Conditioning System; Maintenance And Cleaning - Conrad Electronic 61 59 35 Operating Instructions Manual

i) Connecting an air conditioning system

Normally, the room thermostat is connected to a heating installation. As mentioned before, it
can also be used to control an air conditioning system.
For this purpose, several particularities have to be observed:
• The DIP switch 1 must be set to "ON" (see chapter 11.h).
• The comfort temperature is lower than the lowering temperature. This is very important for
setting and programming.
• The switch-on/switch-off process is reversed compared to the sue of a heating installation:
The cooling system will be switched on, if the room temperature is higher than the defined
temperature.
• In cooling mode, the anti-freeze function is automatically disabled. If the switching program
0 is selected, the room thermostat switches the connected air conditioning system OFF!
• In cooling mode, the time delay of 5 minutes (see chapter 11.h) is always enabled. DIP
switch 2 is without function.

12. Maintenance and Cleaning

The product does not require any maintenance. Never dismantle the product! Repairs may be
carried out only by qualified personnel who are familiar with the hazards involved and the
relevant regulations.
Dust can be easily removed with a vacuum cleaner and a clean soft brush.
To clean the outer surface of the product, use a soft, dry and lint-free cloth.
46