Table of Contents
Advertisement
FusionCol8000-E260 Modular Indirect Evaporative
Cooling System
Quick Guide (Building Scenario)
Procedure
● If the cable-type water sensor is in direct contact with metal, a false alarm may
be generated. Therefore, avoid direct contact with metal during installation. Do
not secure the water detection cable using a metal fastener or bind the cable
to a metal pole. You are advised to use a winding pipe to wrap the water
detection cable. The recommended size is φ20 mm.
● Do not use metal fasteners to bind the water detection cable or bind it to a
metal pole. Otherwise, false alarms may be generated.
● The cable-type water sensor should be installed in a dry environment without
condensation. Do not route the water detection cable in areas that are prone to
rain, vapor, or long-term high humidity.
● Keep the product away from corrosive environments such as acid, sulfur, and
salt. Do not install the water detection cable in a dust-prone area.
● The lead wire must be fixed to ensure that the connector is not stressed.
● Keep the water detection cable away from sharp objects to prevent scratches.
● Do not throw away the plug at the end of the extension cable. Install the plug
at the end of the water detection cable for protection.
Step 1 Determine an appropriate position near the smart cooling product and install the
water detector, for example, by using screws.
Step 2 Connect the water detection cable to the conversion cable.
Figure 7-20 Connecting cables
(1) Conversion cable end B, connecting to the
water detection cable
Step 3 Connect the other end of the conversion cable to the water detector.
Issue 03 (2022-11-25)
NO TICE
NO TE
The water detection cable and conversion cable are interconnected through male and
female connectors.
Copyright © Huawei Digital Power Technologies Co., Ltd.
(2) Water detection cable end A, connecting to
the conversion cable
7 Installing Cables
43
Advertisement
Table of Contents
