Toro 41249 Operator's Manual page 4

3. Remove the blue compression nut from the
fitting on the tank cap connected to the blue
filter tube inside the tank
4. Install the cap-mounted regulating valve and
gasket onto the fitting of the tank cap and
position the valve as shown in
Installing the Tank Loop-Back
Tubing at the Tank
Multi Pro1750 Series and WM (Workman) Turf
Sprayer Systems
1. Assemble blue compression nut
you removed in step
Control Valve (page 3)
compressor to tank loop-back tubing that you
cut in 2 Preparing the Tubing (page
1. Fitting (cap-mounted
regulating valve)
2. Blue compression nut
3. Blue tube (compressor to
tank loop-back tubing)
2. Assemble the blue tube and blue nut into the
fitting of the cap-mounted regulating valve, and
tighten the compression nut by hand
3. Thread the tank cap onto the neck of the tank.
4. Remove the white compression nut from the
fitting on the tank cap
5. Assemble white compression nut onto the clear
tube of the compressor to tank loop-back tubing
(Figure 2).
(Figure 1).
Figure 1.
(Figure
3 of Installing the Foam
onto the blue tube of the
2).
Figure 2
4. Fitting on the tank cap
5. White compression nut
6. White tube (compressor to
tank loop-back tubing)
(Figure
(Figure 2).
6. Assemble the clear tube and white nut into the
fitting of the cap, and tighten the compression
nut by hand.
Installing the Tank Loop-Back
Tubing at the Compressor
Multi Pro 1750 Series and WM (Workman) Turf
Sprayer Systems
1. Route the compressor to tank loop-back tubes
92 cm (3 ft) from the cap to the compression
nuts at the side of the compressor
2) that
g206581
2).
4
(Figure 3).