Table of Contents
Advertisement
Installing the Foam Nozzles
1.
Locate the foam nozzles in loose parts and
install a nozzle to the mounting rod as shown
(Figure
21).
Figure 21
1. Spline-end mandrel
2. Foam nozzle
2.
Connect the blue tube to the upper barb and the
clear tube to the lower barb.
3.
Secure the tubes with the compression nuts that
you installed in
Assembling the Compression
Nuts (page
10).
4.
Repeat steps
1
through
other side of the machine.
g007667
3. Blue tube and blue
compression nut
4. Clear tube and white
compression nut
3
for the boom at the
7
Connecting the Boom
Tubes at the Compressor
No Parts Required
Procedure
1.
Route the foam tubes for the right boom as
shown in
Figure
1. Blue tubes
2. Liquid fitting (left boom)
3. Air fitting (left boom)
4. Foam tubes (left
boom)—Multi Pro 1750
and WM Multi Pro Series
4.9 m (16 ft) or Multi Pro
5800 Series 4.9 m (16 ft)
5. Foam tubes (right
boom)—Multi Pro 1750
and WM Multi Pro Series
5.5 m (18 ft) or Multi Pro
5800 Series 4.3 m (14 ft)
2.
Insert the clear tube into the air fitting at the side
compressor plate
3.
Insert the blue tube into the liquid fitting at the
side compressor plate
4.
Route the foam tubes for the left boom as shown
in
Figure
22.
12
22.
Figure 22
6. Electrical connector
7. Air fitting (right boom)
8. Liquid fitting (right boom)
9. Clear tubes
(Figure
22).
(Figure
22).
g411476
Advertisement
Table of Contents
