Table of Contents
Advertisement
1. Upper boom tube
2. Lower half of the bracket
clamp
4.
Install the second bracket assembly 7 to 10 cm
(3 to 4 inches) inboard from the first bracket.
5.
Install a set screw in the top hole of each spacer.
6.
Install the mounting rod, with the spline end
outward, into the holes in the spacers.
Note:
Use the set screws to secure the rod in
the desired position.
7.
Repeat steps
2
through
other side of the machine.
3. Spacer (note orientation)
4. Lower half of the bracket
clamp
6
for the boom at the
Figure 20
5. Clamp screw
6. Spacer nut
11
7. Set screw
8. Mounting rod
g007666
Advertisement
Table of Contents
