Toro 41249 Operator's Manual page 6

3. Route the free end of the clear tube 92 cm (3 ft)
from the fitting of the cap to the fitting at the side
of the compressor with the white compression
nut (Figure 4 and
1. Compression nut
(white—compressor
fitting)
2. Clear tube—foam density
tubes 4.9 m (16 ft)
3. Clear tube—92 cm (3 ft)
4. Remove the white compression nut
and assemble it onto the clear tube 92 cm (3 ft).
5. Assemble the clear tube and white compression
nut onto the fitting at the side of the compressor,
and tighten the white compression nut by hand
(Figure 5).
6. Remove the blue compression nut from the
fitting at the side of the compressor
7. Assemble the blue compression nut onto the
blue tube (Figure
4.9 m (16 ft).
8. Assemble the blue tube and blue compression
nut onto the fitting at the side of the compressor,
and tighten the blue compression nut by hand
(Figure 5).
9. Remove the blue compression nut from the
fitting at the cap for the tank
10. Assemble the blue compression nut onto the
clear tube (Figure
4.9 m (16 ft).
11. Assemble the clear tube and blue compression
nut onto the fitting at the cap for the tank,
and tighten the blue compression nut by hand
(Figure 4).
Figure 5).
Figure 5
4. Blue tube—foam density
tubes 4.9 m (16 ft)
5. Compression nut
(blue—compressor fitting)
(Figure
(Figure
5) of the foam density tubes
(Figure 4).
4) of the foam density tubes
Routing the Foam-Density-Control
Tubes
Multi Pro 5800 Series Sprayers
1. Route the foam density tubes 4.9 m (16 ft)
forward from the tank and compressor bracket
(located below the chemical tank and behind
the fuel tank) along the frame channel of the
machine, and toward the area under the seat
box (Figure
g411623
1. Foam tube
2. Lift the seat, and continue to route the tube
forward along the wire harness of the machine,
5)
through the support clamp, and under the floor
plate (Figure
5).
Multi Pro 5800 sprayer shown
1. Front of the machine
2. Tube pair 14.9 m (16 ft)
3. Route the tube to the valve mount.
•
For model year 2015 and earlier sprayers:
Route the tube along the existing wire
harness through the console opening
9).
6
6).
Figure 6
2. Fuel tank
7).
Figure 7
3. Support clamp
g007700
g195758
(Figure