Toro 41249 Operator's Manual page 9

Figure 13
Multi Pro 5000 Series shown
1. Foam tube on the right
boom
B. Align the end of the tube with the end of the
upper support pole.
Note:
Use a cable tie to secure the foam
tube to the brace using the holes in the
brace (Figure
Note:
Leave a small excess of tube at
the end of the boom to allow the boom to
extend.
Figure 14
1. Cable tie
C. Continue to route the tube along the existing
boom supply tube.
Note:
Use ties to secure the tube to the
brace at the positions shown in
2. Cable ties
14).
Figure
1. Cable ties
D. Repeat the process for the left boom, but
route the tube along the front side of the
upper support pole.
g197029
Important:
pinched when the booms are in the "X"
transport position if they are installed on
the wrong side.
2. Route the 2 foam tubes from the booms forward
to the side of the machine with the mounting
bracket
Important:
they will be pinched or pulled out of place.
1. Cable ties
g007660
15.
9
Figure 15
The foam tubes will be
(Figure 16).
Do not route the tubes where
Figure 16
Multi Pro 1750 Sprayer
2. Tube
g007655
g023900