Toro 41249 Operator's Manual page 8

Figure 11
Multi Pro 5800 model year 2015 and earlier
1. Valve
2. Valve mount
Figure 12
Multi Pro 5800 model year 2016 and later
1. Valve
2. Decal 112-7890
g206499
3. Decal 112-7890
g206522
3. Valve mount
4
Installing the Foam Marker
Finishing Kit and the
Bracket
Parts needed for this procedure:
1 Foam marker finishing kit (sold separately)
See the installation instructions that came with
the foam marker finishing kit.
5
Routing the Foam Tubes
Parts needed for this procedure:
1 Foam tube
8 Cable ties
Routing the Foam Tubes to the
Booms
1. Install the foam tubes to the booms.
Note:
Install the shorter length of tube to the
boom on the same side as the bracket; install
the longer tube to the boom on the side opposite
of the bracket.
A. On the right boom, install the foam tube
along the rear side of the upper support
pole (Figure
Important:
pinched when the booms are in the "X"
transport position if they are installed on
the wrong side.
8
13).
The foam tubes will be