Raven RS1 Installation Manual page 17

For fendt 200 vfp varioguide (with fendt one, model year 2021)

Hide thumbs Also See for RS1:

Table of Contents

2. Locate the X3058 connector at the roof line on the right side of the machine cab.

FIGURE 7. OEM X3058 Connector Location

NOTE:

If installed on the machine, the AGCO Connect module will be connected to this plug.

3. Disconnect any existing components from the plug and connect the Fendt 200 gen3 V-Bus cable (P/N 115-

4010-241) to the X3058 connector.

4. Connect the remaining Deutsch connector to the AGCO Connect Module if installed in your tractor.

5. Locate the X4250 connector at the back of the roof.

FIGURE 8. OEM X4250 Connector

6. Disassemble X4250 connector by pushing the yellow tabs out and down.

7. Remove the connector from the pass-through and remove the yellow wedge on top.

Installation: Connect the Harness

step 6

step 7

INSTALLATION

Table of Contents