Save & Exit Setup - Boser HS-6250 Manual

When a password has been enabled, you will be prompted to enter it
every time you try to enter Setup. This prevents an unauthorized
person from changing any part of your system configuration.
Additionally, when a password is enabled, you can also require the
BIOS to request a password every time your system is rebooted. This
would prevent unauthorized use of your computer.
You determine when the password is required within the BIOS
Features Setup Menu and its Security option (see Section 3). If the
Security option is set to "System", the password will be required both at
boot and at entry to Setup. If set to "Setup", prompting only occurs
when trying to enter Setup.
4.15 Save & Exit Setup
Pressing <Enter> on this item asks for confirmation:
Pressing "Y" stores the selections made in the menus in CMOS – a
special section of memory that stays on after you turn your system off.
The next time you boot your computer, the BIOS configures your
system according to the Setup selections stored in CMOS. After saving
the values the system is restarted again.
CMOS Setup Utility－Copyright ©1984-2001 Award Software
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management
PnP/PCI Configura
PC Health Status
Esc : Quit
F10 : Save & Exit Setup
Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
SAVE to CMOS and EXIT (Y/N)? N
: Select Item
Save Data to CMOS
word
etup
Saving
59