Battery - Ingenico AXIUM EX6000 User Manual

4.4 Battery

4.4.1 Charging the battery
When used daily, the terminal charges its battery each time the power adapter is
connected. Charging starts automatically.
In order to charge the battery:
Using the power adapter
Connect the power adapter to the terminal USB type-C connector located on the left
side of the terminal.
Connect the power adapter to the power supply mains network.
When charging, a red charge light at the top of the screen will display. This light will
turn green when the terminal is fully charged" (check that behavior!)
4.4.2 Installing the battery
WARNING
Check that the terminal is not connected to the main electric network.
Power off terminal
Turn the terminal over and remove the battery door
Locate the battery pack connector beside the battery compartment
Plug the battery pack connector according to the connector locating system.
Place the battery pack in its compartment
Replace the battery door
AXIUM EX6000
11/17
15
Banks and Acquirers International Holding SAS
Copyright© 2022Ingenico–
All rights reserved