Linking; Connection Of The Dmx Line - ProLights HZ660D User Manual

Button
FUNCTION
UP
DOWN
TIMER
VOLUME
MANUAL

2.2 Linking

Several units may be interconnected in this way.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units are
connected in a chain.

2.3 Connection of the DMX line

DMX connection employs standard XLR connectors. Use shielded pair-twisted cables with 120Ω impedance
and low capacity.
The following diagram shows the connection mode:
DMX - INPUT
XLR plug
Select first interval set, duration set, DMX address, door sensor, direct haze, fan speed, their
the numerical values change by using the UP/DOWN buttons.
• INTERVAL SET: Setting of interval time from 1 - 200 seconds effective when starting the
timer function
• DURATION SET: Setting of duration time from 1 - 200 seconds, effective when starting
the timer function.
• DMX ADDRESS: setting of DMX address, their the numerical values change by using the
UP/DOWN buttons.
• DOOR SENSOR: when enabled prevents the haze machine to burst fog if the upper lid is
closed, a warning tone is then emitted. Press the DISABLE button to disable the DOOR
SENSOR at your own risk. Press the VOLUME button to activate it again.
• DIRECT HAZE: a function allowing a direct emissione of fog. Press the volume to activate
DIRECT HAZE mode. Press MANUAL button to disable it.
• FAN SPEED: Select the fan speed (0 - 10).
Button for increasing numerical value.
Button for decreasing numerical value.
Puffing timely according to the adjusted volume, duration, interval, on the display. This func-
tion can be executed under any circumstances.
Pushing this button, the unit will issue the desided volume in any opertive mode. If the but-
ton is pushed again the unit will return to its original state. This function can be executed
under any circumstances.
Pushing this button, the unit will issue its maximum volume. When the button is released the
unit will return to its original state. This function can be executed under any circumstances.
Pin1 : GND - Shield
1 2
Pin2 : - Negative
3 Pin3 : + Positive
HZ660D
Direction
DMX - OUTPUT
2 1
XLR socket
3
7