Master/Slave Mode; Linking; Dmx Mode; Dmx Addressing - ProLights Tribe LUMIPIX12UQ User Manual

10

3.8 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 13).
• Use any one of the standalone modes for the master unit.
• Set the slaves to the same DMX modes.

3.9 LINKING

1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units
are connected in a chain.

3.10 DMX MODE

• Press the button MENU so many times until shows, 4CH, 7CH, 9 CH, 12 CH, 17 CH and press the button ENTER
to confirm.
• Press the button UP/DOWN to select the desired DMX address d1 - d512. Press and hold to scroll quickly.
Press ENTER button to store.
The tables on page 14 indicate the operating mode and DMX value. The LUMIPIX12UQ is equipped with
3 pole XLR connections.

3.11 DMX ADDRESSING

To able to operate the LUMIPIX12UQ with a light controller, adjust the DMX start address for the first a
DMX channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX
channel, adjust the start address 33 on the LUMIPIX12UQ. The other functions of the light effect panel are
then automatically assigned to the following addresses.
An example with the start address 33 is shown below:
LUMIPIX12UQ