Planet WGS-4215 Series User Manual page 360

2. Select "Source File = Running Configuration" and "Destination File = Startup Configuration".
3. Press the "Apply" button to save running configuration to startup configuration.
4.16.2 Factory Default
You can reset the configuration of the switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
to reset the configuration to Factory Defaults.
After the "Factory" button is pressed and rebooted, the system will load the default IP settings as follows:
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
Figure 4-16-1 Factory Default Page Screenshot
360
User's Manual of WGS Managed Series
Figure 4-16-1 appears and clicks