Cleaning And Disinfecting Of Internal Components - Bartscher 900004 Original Instruction Manual

Drain Tap Assembly
1. In order to assemble the drain tap,
perform steps shown in Fig. 30
through 25 (section 6.2.5) ion
reverse order.
2. To fix the lever (F), and rod (D)
press fro,m the internal side until
guides are out, and then insert the
lever (F) and slowly release the rod
(D).
Drain Tap Installation
1. Keep the tab pressed and make
sure that the rod is completely out.
2. Insert the drain tap and press it
until the tap clicks back to the initial
EN
position.
6.2.8

Cleaning and Disinfecting of Internal Components

CAUTION!
Make sure that the appliance is switched off.
Switch the ON/OFF switch to 'OFF' position.
During disinfection, proceed the following way:
– prepare disinfection solution (section 6.2.6);
– fill the tank with disinfection solution;
– leave for 30 minutes so that the solution starts acting;
– empty the tank;
– to end with, rinse the tank and the bowl thoroughly to remove the
residues of the disinfecting agent.
28 / 34
Cleaning and Maintenance
Fig. 39
Fig. 40
900004