Cleaning And Descaling - Bartscher MultiTherm A200050 Instruction Manual


The device is equipped with protection against overheating. If the device happens
to be empty when turned on, the overheating protection will be activated. Remove
the plug from its socket and leave the device to cool for approx. 30 minutes.
Let the liquid drain. Pull the device with the drainer upward out of the socket.
Next, press the RESET button located at the bottom of the device. The device is
ready for use. In case the device does not work properly afterwards, contact you
customer service.

6. Cleaning and descaling

WARNING!
Disconnect the device from the power supply
(unplug!) before cleaning. Let the device cool down.
Never clean the device with use of water jet!
Be careful and do not let the water into the device.
o The device should be cleaned regularly.
o The surface of the device should be cleaned with a damp cloth. For tenacious stains
a mild detergent can be used. Do not use any sprays or aggressive detergents.
o Clean the device thoroughly inside and rinse it with clean water.
o Do not use steel wool for cleaning purposes. Parts of the steel wool can loosen and
settle in the stop valve and lead to damages of the seal faces.
o If the device is used daily the whole faucet mechanism has to be cleaned once a week.
If the device is used less often, it may be cleaned less frequently. For cleaning the
faucet bonnet unscrew bonnet, remove silicone seat cup and wash the parts in warm
soapy water. Clean the inside of the faucet and the connection to the device by using a
small bottle brush.
CAUTION!
Never insert the brush in the assembled faucet since it will puncture
the seat cup.
o Never use any kind of inflammables for cleaning purposes as, in case of
reconnection, this increases the risk of fire and explosion.
- 30 -