IBM ServeRAID User Reference page 76

Figure 27. "Create spanned arrays" window
3. Create spanned arrays by doing the following:
4. Click Next; the "Create logical drives" window opens. Continue with step 9 of
Installing the device driver
Complete the following steps to finish the active controller installation:
1. Install the fault-tolerant device driver located on the IBM ServeRAID Failover
2. Shut down the server.
60
IBM ServeRAID: User's Reference, Version 5.10
d. Select the Span arrays check box; then, click Next. The "Create
spanned arrays" window opens.
a. In the list of arrays, click the arrays that you want to add to your spanned
array.
b. Click (Add selected arrays) to add the arrays to the spanned array.
You can click
array.
c. To create additional spanned arrays, click the New spanned array tab in the
right pane; then, repeat steps 3a and 3b.
"Configuring ServeRAID arrays and logical drives" on page 55.
Support for Windows NT and Windows 2000 diskette. This can be done either
during or after installing Windows 2000 or Windows NT 4.0. For instructions,
see the IBM ServeRAID Device Driver Installation Instructions on the IBM
ServeRAID Support CD.
(Add all arrays) to move all arrays to the spanned