2. Click Custom configuration.
3. Click Next. The "Create arrays" window opens. If you want to create spanned
arrays, go to step 2 of "Creating spanned arrays" on page 42.
Figure 12. "Create arrays" window
4. Click the appropriate tab in the right pane; then, from the list of ready drives,
select the drives you want to move to the array.
5. Click
(Add selected drives) to add the drives to the array. You can
click
(Add all drives) to move all ready drives to an array.
6. Repeat steps 4 and 5 for each additional array or hot-spare drive that you
want to configure.
7. After you select the ready drives for your arrays and hot-spare drive, click
Next. The "Create logical drives" window opens.
Chapter 4. Configuring ServeRAID controllers
39