Serveraid Startup (Post) Messages - IBM ServeRAID User Reference

Message Explanation
Your server has One or more logical drives are
an error due to a blocked. A blocked logical drive cannot
Blocked Logical be accessed. See "Logical-drive-state
Drive. descriptions" on page 32 and
"Rebuilding a defunct drive" on
page 157 for more information.

ServeRAID startup (POST) messages

During power-on self-test (POST), the ServeRAID controller compares the stored
configuration information to the configuration that is actually present. If a
discrepancy exists, one or more status messages appear after POST is completed,
but before the operating system starts.
When you press F2 for detailed information, the following register information
appears on the screen.
The controller status codes include the interrupt status port register (ISPR) code,
the basic configuration status (BCS) register code, and the extended configuration
status (ECS) register code.
If no errors occur during POST, the following register information is displayed: ISPR
= EF10, BCS = 0F or 09, and ECS = 00
If an error occurs, see "ISPR register codes" on page 151 for the ISPR error codes
and "BCS and ECS register codes" on page 151.
150
IBM ServeRAID: User's Reference, Version 5.10
Copyright IBM Corp. 1995, 2001
Controller 1 Slot 4, Logical Drive=1, Firmware=4.00.20, Status=Fail
2 Drives(s) not responding or found at new location(s)
Press: F2 - Detailed information
F4 - Retry
F5 - Change the configuration and set drive(s) defunct
F10 - Continue booting without changing the configuration
----------------------------------------------------------------------
Online Drive on Channel 2 SCSI ID 0 is not responding
Online Drive on Channel 2 SCSI ID 1 is not responding
----------------------------------------------------------------------
Controller Status Codes: ISPR = EF10 BCS = 07 ECS = 08
Press PgUp = Page Up
Action
Press F4 to unblock the logical drive, or press F5 to
continue without unblocking.
IBM ServeRAID BIOS
BIOS Version: 4.10.05
Detailed information
PgDn = Page Down Esc = Exit panel