Output Wiring - HikRobot SC2000E Series Quick Start Manual

recommended to use 1 KΩ pull-up resistor.
Figure 7-8 Input Signal Connecting to NPN Device (External Pull-Up Resistor Used)
Switch
If the input signal is switch, and its wiring is shown below.

7.3.2 Output Wiring

Note
Output signal wiring may differ by external device types.
PNP Device
SC2000E Series Vision Sensor Quick Start Guide
Device Power
Input Signal
Device Power Ground
GND of PWR and VCC
Figure 7-9 Input Signal Connecting to Switch
Device Power
Output Signal
Device Power
GND of PWR and VCC
Figure 7-10 Output Signal Connecting to PNP Device
VCC
PWR
●
●
●
PWR
Device Power
Input Signal
Device Power Ground
GND of PWR and VCC
VCC
PWR
●
Ground
18
NPN Device Power
Signal Line
NPN Power Ground
> 3.3 V
0 V
PNP Device Power
Signal Line
PNP Power Ground
NPN
Device
PNP
Device