Table of Contents
Advertisement
Cayman 3220-H User's Guide
December 2000
2. Enter information about the system location in the System
Location field.
For example, you might enter the building, floor, or room
number where the Cayman 3220-H is located.
3. If you want the Cayman 3220-H to use authentication
traps, click the Authentication Traps On radio button.
If SNMP trapping is enabled, your Cayman 3220-H sends
authentication traps to all SNMP trap destinations. You must
enable trap authentication before you set up your trap
destinations.
4. Identify the SNMP communities to which the Cayman
3220-H belongs by entering a community name in the
Communities field and clicking the Add button.
By default, the Cayman 3220-H is associated with the public
community. You can associate as many as 16 communities with
the Cayman 3220-H.
5. If your Cayman 3220-H is using authentication traps,
identify the destinations to which the Cayman 3220-H
should send SNMP trap messages.
Enter the IP address of a host acting as an SNMP console in the
IP Address field.
6. Optionally, enter the name of the community for which
the trap destination is responsible in the Community field.
The optional community name identifies the name of the
Cayman 3220-H community, which is included in the trap
message the device sends to the management console. This
name, which is not used for authentication, does not have to
match a predefined community name.
7. Click the Add button.
8. Click the Save button to store your modified
configuration in the Cayman 3220-H memory.
Configuring Your Cayman 3220-H
3-59
Advertisement
Table of Contents
