Cayman Systems 3220-H User Manual page 116

Using the Command Line Interface
4-34
You can configure as many as 16 static IP routes for a Cayman
3220-H. Use the following commands to maintain static routes to the
Cayman 3220-H routing table:
set ip static-routes destination-network net_address
Specifies the network address for the static route. Enter a network
address in the
net_address
argument cannot be 0.0.0.0.
net_address
set ip static-routes destination-network net_address
netmask netmask
Specifies the subnet mask for the IP network at the other end of the
static route. Enter the
The subnet mask associated with the destination network must
represent the same network class (A, B, or C) or a lower class (such
as a class C subnet mask for class B network number) to be valid.
set ip static-routes destination-network net_address
interface { ip-address | ppp-vccn }
Specifies the interface through which the static route is accessible.
set ip static-routes destination-network net_address
gateway-address gate_address
Specifies the IP address of the gateway for the static route. The
default gateway must be located on a network connected to the
Cayman 3220-H configured interface.
set ip static-routes destination-network net_address
metric integer
Specifies the metric (hop count) for the static route. The default
metric is 1. Enter a number from 1 to 15 for the integer argument to
indicate the number of routers (actual or best guess) a packet must
traverse to reach the remote network.
argument in dotted decimal format. The
argument in dotted decimal format.
netmask
Cayman 3220-H User's Guide
December 2000