Table of Contents
Advertisement
Configuring Your Cayman 3220-H
3-22
10. Enter the IP address for the remote peer in the Peer
Address field.
Enter
if you want the Cayman 3220-H to negotiate the
0.0.0.0
IP address for the remote peer.
11. Use the Admin Restrictions list to specify whether the
Cayman 3220-H accepts administrative commands
received over this virtual circuit.
Options are:
None – All traffic is accepted over this port.
Admin-Disabled – Router traffic is accepted over this port
but administration commands are ignored.
Admin-Only – Administration commands are accepted over
this port but router traffic is ignored.
12. Use the RIP-Send list to specify whether you want the
Cayman 3220-H to send Routing Information Protocol
(RIP) messages to other routers.
RIP lets your Cayman 3220-H inform other routers of routes
available through its interfaces. Options are:
Off – Do not send RIP messages to other routers.
RIP-1 – Broadcast routing information in RIP version 1
format.
RIP-2– Multicast routing information in RIP version 2
format.
RIP-1 Compatibility – Broadcast routing information in RIP
version 2 format.
You cannot use RIP when network address translation is turned
on.
13. Use the RIP-Receive list to specify whether you want the
Cayman 3220-H to accept Routing Information Protocol
(RIP) messages from other routers.
RIP lets your Cayman 3220-H learn about routes available
through other routers. Options are:
Cayman 3220-H User's Guide
December 2000
Advertisement
Table of Contents
