Cayman Systems 3220-H User Manual page 112

Using the Command Line Interface
4-30
set ip gateway default ip_address
Specifies the IP address of the default IP gateway. Only used if you
specify that the gateway can be reached at a fixed IP address and not
through a PPP virtual circuit.
WAN-to-WAN Routing Settings
Use the following command to configure settings for routing
between WAN connections.
set ip interwan-routing { on | off }
Enables or disables routing between WAN connections.
IP-over-PPP Settings
Use the following commands to configure settings for routing IP over
a virtual PPP interface.
set ip ip-ppp vccn option { on | off }
Enables or disables IP routing through the virtual PPP interface. By
default, IP routing is turned off. You must enable IP routing before
you can enter other IP routing settings for the virtual PPP interface.
If you turn off IP routing and save the new configuration, the
Cayman 3220-H clears IP routing settings.
set ip ip-ppp vccn address ip_address
Assigns an IP address to the virtual PPP interface. If you specify an IP
address other than 0.0.0.0, your Cayman 3220-H will not negotiate
its IP address with the remote peer. If the remote peer does not
accept the IP address specified in the
the link will not come up.
The default value for the
indicates that the virtual PPP interface will use the IP address
assigned to it by the remote peer. Note that the remote peer must be
configured to supply an IP address to your Cayman 3220-H if you
enter 0.0.0.0 for the
ip_address
argument is 0.0.0.0, which
ip_address
argument.
ip_address
Cayman 3220-H User's Guide
argument as valid,
December 2000