Cayman Systems 3220-H User Manual page 54

Configuring Your Cayman 3220-H
3-32
1. Enter the number of the virtual path identifier in the VPI
field.
The VPI is a number in the range 0-255. Consult your ATM
transport administrator for what number you should enter in
this field.
2. Enter the number of the virtual circuit identifier in the
VCI field.
The VCI is a number in the range 0-65535. Consult your ATM
transport administrator for what number you should enter in
this field.
3. Use the IP Interface radio buttons to enable or disable IP
traffic over this virtual circuit.
4. Use the NAT radio buttons to enable or disable network
address translation for this virtual circuit.
5. Enter the IP address the Cayman 3220-H will use on this
virtual circuit in the IP Address field.
The IP address you enter must not be in use by other devices on
this virtual circuit. Enter
3220-H to receive the IP address information for this interface
from a DHCP server on the other end of the ATM connection.
6. Enter the subnet mask for the network connected to this
virtual circuit in the Net Mask field.
The subnet mask specifies which bits of the 32-bit binary IP
address represent network information. Most sites should use
255.255.255.0 for their subnet mask.
7. Use the Admin Restrictions list to specify whether the
Cayman 3220-H accepts administrative commands
received over this virtual circuit.
Options are:
None – All traffic is accepted over this port.
if you want the Cayman
0.0.0.0
Cayman 3220-H User's Guide
December 2000