Cayman Systems 3220-H User Manual page 108

Using the Command Line Interface
4-26
set ip dsl vccn rip-send { off | v1 | v2 | v1-compat |
v2-MD5 }
Specifies whether the Cayman 3220-H should use Routing
Information Protocol (RIP) broadcasts to advertise its routing tables
to other routers on your wide area network (WAN). RIP Version 2
(RIP-2) is an extension of the original Routing Information Protocol
(RIP-1) that expands the amount of useful information in the RIP
packets. While RIP-1 and RIP-2 share the same basic algorithms, RIP-2
supports several new features, including inclusion of subnet masks
in RIP packets and implementation of multicasting instead of
broadcasting (which reduces the load on hosts which do not
support routing protocols). RIP-2 with MD5 authentication is an
extension of RIP-2 that increases security by requiring an
authentication key when routes are advertised.
Depending on your network needs, you can configure your Cayman
3220-H to support RIP-1, RIP-2, or both.
set ip dsl vccn rip-receive { off | v1 | v2 | v1-compat |
v2-MD5 }
Specifies whether the Cayman 3220-H should use Routing
Information Protocol (RIP) broadcasts to update its routing tables
with information received from other routers on your wide area
network.
set ip dsl vccn rip-send-keyid keyid
Specifies the authentication key that will be included with all
outgoing RIP packets if
authentication key must match the key the remote router is
expecting, or the RIP update will be ignored. RIP authentication
keys can be 1-16 characters long, and can include spaces and special
characters. You must enclose the authentication key string in double
quotes ("").
set ip dsl vccn rip-receive-keyid keyid
Specifies the key that will be used to authenticate all incoming RIP
packets if is selected for
v2-MD5
is selected for
v2-MD5
. When your Cayman
rip-send
Cayman 3220-H User's Guide
. This
rip-send
December 2000