Boot Setting Commands - Cayman Systems 3220-H User Manual

Boot Setting
Commands
Cayman 3220-H User's Guide
December 2000
revert
The revert command retrieves the saved version of settings from
non-volatile storage and overwrites any changes made since the last
save.
save
The save command saves the EPROM settings you have entered or
changed to non-volatile storage in the Cayman 3220-H.
show
The show command displays the current EPROM settings for the
Cayman 3220-H and a brief explanation of those settings. For
example, the show command produces the following:
BootPROM> show
flash on
ip 0
file <unset>
bootp on
autoboot 10
autoprog never
Cayman 3220-H serial no. 800700, h/w rev. 1, eprom v1.3
Last install status: code flash successfully programmed
flash image 1: Cayman 3220-H 5.3.0
The following commands specify boot settings for the Cayman
3220-H.
autoboot { retry_count | off }
The autoboot
retry_count
whole number) sets the number of times the Cayman 3220-H should
attempt to start an image and run it when powered up. If you enable
autoboot with the autoboot
(flash will be tried)
(no ip address; tftp will not be tried)
(must be set for tftp download)
(will attempt configuration via bootp)
(will autoboot on powerup, and will try
10 times)
(will never program a downloaded
image into flash)
command (where
retry_count
is any
retry_count
command, the
Diagnostic Console
B-7