Buffalo HD-H Series User Manual page 16

"ARRAY PARAMETERS SETTING!" will be displayed on the LCD panel.
ARRAY PARAMETERS
SETTING!
3
Press the mode button 8 times and "Host Mode" is displayed on the LCD panel.
Host Mode
Thunderbolt2
The messages under "Host Mode" may be different depending on your settings.
4
Press the select button and "Host Mode eSATA Enabled" is displayed.
Host Mode
eSATA Enabled
5
Press the mode button once and "USB3.0 Host" is displayed.
USB3.0 Host
Disabled
The messages under "USB3.0 Host" may be different depending on your settings.
6
Press the select button and "USB3.0 Host Disabled" is displayed.
USB3.0 Host
Disabled
7
Press the mode and select buttons on the front panel at the same time.
The settings will be configured.
8
"POWER DOWN PLEASE!" will be displayed. Turn the unit off and then on while holding down the init button
on the back of the unit.
POWER DOWN
PLEASE!
9
Press the select button once. The firmware version will be displayed.
Firm ware is
Ver.x.xxx xxxx
10
Press the mode button 10 times and "eSATA Host Speed" is displayed.
eSATA Host
Speed 6Gbps
11
Press the select button and "3Gbps" is displayed.
If you set to "6Gbps", the unit may not work properly.
eSATA Host
Speed 3Gbps
12
Press the mode and select buttons on the front panel at the same time.
The settings will be configured.
15