The power LED will light up blue while the unit is on.
3
Access LED
The access LED will blink green while hard drives are accessed.
4
Fail LED
If a drive fails, its LED will turn amber.
5
LCD Panel
This display shows the status of many current settings.
6
Mode Button
This button is used in the following situations:
1) Selecting options.
2) Stopping the beeps.
7
Select Button
Select the value to configure.
8
Drive Lock
Open the front panel with the key to replace hard drives.
9
HDD LED
Normally, these LEDs blink blue when hard drives are working. If a drive fails or is in recovery
amber.
*The unit is in recovery if "RAID-x RECOVERING 0%" is displayed on the LCD panel.
10
Internal Hard Drive
There are 6 hard drives are inserted (number 0 to number 5).
11
Reset Button
Press this button while the power is on (power LED is lit) to reboot the unit.
Rear
⑫
⑬
⑭
⑮
⑯
12
Init Button
Settings will be displayed when powering on while holding down the init button.
13
eSATA Port
⑰
⑱
⑲
⑳
10
, its LED will turn
*