Connecting By Usb 3.0 - Buffalo HD-H Series User Manual

2
The icon will be displayed on the Desktop.
If the icon is not displayed, verify if the unit is added to the sidebar in Finder.

Connecting by USB 3.0

The USB 3.0 port is disabled by default. Disable eSATA port and enable USB 3.0 port before use.
Enabling USB 3.0 Port
1
Use the included power cable and connect the unit to a outlet.
2
Open the front panel and turn the unit on while holding down the init button.
"ARRAY PARAMETERS SETTING!" will be displayed on the LCD panel.
ARRAY PARAMETERS
SETTING!
3
Press the mode button 8 times and "Host Mode" is displayed on the LCD panel.
Host Mode
Thunderbolt2
The messages under "Host Mode" may be different depending on your settings.
4
Press the select button and "Host Mode eSATA Disabled" is displayed.
Host Mode
eSATA Disabled
5
Press the mode button once and "USB3.0 Host" is displayed.
USB3.0 Host
Disabled
The messages under "USB3.0 Host" may be different depending on your settings.
6
Press the select button and "USB3.0 Host Enabled" is displayed.
USB3.0 Host
Enabled
7
Press the mode and select buttons on the front panel at the same time.
The settings will be configured.
8
"POWER DOWN PLEASE!" will be displayed. Turn the unit off and then on while holding down the init button
on the back of the unit.
POWER DOWN
PLEASE!
13