Connecting By Esata - Buffalo HD-H Series User Manual

9
Press the select button once. The firmware version will be displayed.
Firm ware is
Ver.x.xxx xxxx
10
Press the mode button 10 times and "eSATA Host Speed" is displayed.
eSATA Host
Speed 6Gbps
11
Make sure "6Gbps" is displayed on the LCD panel. If "3Gbps" is displayed, press the select button and change it
to "6Gbps".
If you have configured to "3Gbps", the unit may not work properly.
12
Press the mode and select buttons on the front panel at the same time.
The settings will be configured.
13
Turn the unit off and then on when "POWER DOWN PLEASE!" is displayed on the LCD panel.
POWER DOWN
PLEASE!
Connecting the Unit to a Computer
For Windows:
1
Connect the unit and computer using a USB cable.
2
The hard drive icon will be displayed.
3
Format the drive referring the "Format (Initialization)" section in chapter 7.
For Mac:
1
Connect the unit and the Mac using a USB cable.
2
The
If the icon is not displayed, verify if the unit is added to the sidebar in Finder.

Connecting by eSATA

The eSATA port is disabled by default. Enable eSATA port and configure "eSATA Host Speed" to "3Gbps" before use.
Enabling eSATA Port
1
Use the included power cable and connect the unit to a outlet.
2
Open the front panel and turn the unit on while holding down the init button.
icon will be displayed on the Desktop.
14