Table of Contents
Advertisement
NetPA AT Series • Setup Guide (Continued)
Route Inputs and Outputs
Click the + box next to the input channels (receivers) on the NetPA (NetPA-Classroom-01 in the example above).
1.
All device outputs (transmitters) display horizontally.
Click the junction of the desired connection
2.
(Example: DMP128-LectureHall Output-01 to NetPA-Classroom-01 INPUT-MONO).
A checkmark at the junction indicates the connection is made. A checkmark is also placed next to the receiver channel.
NOTE:
An input (receiver) can connect to only one output (transmitter). An output (transmitter) can connect to multiple
inputs (receivers).
Click the junction again to disconnect the input from the output.
3.
See the "Dante Controller" section of the NetPA AT Series user guide for information on Dante Controller operation.
Step 12 — Setting the Gain Potentiometer
Turn up the gain potentiometer to the desired level. When the pot is set to 0 dB, and a 0 dBFS signal is
transmitted through the Dante port, the amplifier outputs full power.
Use a Tweeker or small screwdriver to adjust the audio input gain for the corresponding channel. The
analog potentiometers control the gain from
NOTE:
•
The potentiometer affects the gain post DAC and pre amplifier stage.
•
The gain potentiometer does not adjust the level of the line output.
8
=
(full attenuation) to 0 dB (no gain) to + 6 dB gain.
NetPA 502 AT
GAIN
1
2
-4
-4
-6
-2
-6
-2
-8
0
-8
0
-12
+2
+2
-20
+4
+4
-
-
+6
+6
NetPA 1001-70V AT
GAIN
-4
-6
-2
-8
0
-12
+2
-20
+4
-
+6
Advertisement
Table of Contents
