Extron electronics NetPA AT Series Setup Manual page 6

NetPA AT Series • Setup Guide (Continued)
Click Apply. A warning opens.
6.
Click Yes to enter the new name, then close the
7.
The new name is written to the NetPA AT. Repeat as necessary for all NetPA AT devices.
NOTE:
After the NetPA AT is renamed, it can remain connected to the network. However, subsequent devices must be
connected one at a time and renamed before the next device is connected.
Identifying the Physical Device
If the amplifier needs to be physically identified, the identify device tool can be used to aid in its location.
Start with steps 1 through 3 of
1.
To identify the NetPA, click on the "eye" icon on the toolbar.
2.
Both the front panel power LED (see
3.
blink amber at a rate of 0.5 Hz for ten seconds, after which the LEDs return to their previous state.
Locate the unit with the blinking LEDs.
4.
NOTE:
For advanced network setup, refer to the user guide.
6
Rename the NetPA AT
on page
figure 6, A , on page 10) and the rear panel link LED
dialog.
4.
F (see figure 1, F , on page 1)