Table of Contents
Advertisement
Step 8 — Powering On the Equipment
ATTENTION:
The amplifier must be powered on last.
ATTENTION :
L'amplificateur doit être allumé en dernier.
Reconnect all power cables and switch on all other equipment before powering on the amplifier. The front panel power LED of the
NetPA AT lights green.
Step 9 — Installing Dante Controller for Windows Software
Dante Controller from Audinate is required to select and route digital inputs and outputs to connected Dante-compatible devices.
Install Dante Controller on a PC running Microsoft
the product page on the
identification on the network.
Downloading Dante Controller for Windows
The software application is available at www.extron.com.
From www.extron.com, enter NetPA AT in the search field and press <Enter>.
1.
The NetPA AT product page opens.
NetPA AT Product Page
Figure 2.
Click Downloads (
2
2.
Click Dante Controller (
3.
3
3
Windows
®
Extron
website. Dante Controller must be installed to rename the connected NetPA AT to assist
2
2
). The Downloads panel opens. Dante Controller is listed.
3
).
7
or newer. For full details about computer requirements, see
®
®
1
1
Product Category
3
Advertisement
Table of Contents
