Extron electronics NetPA AT Series Setup Manual page 7

Step 11 — Dante Operation
Select Devices
After the receiver inputs of the NetPA AT are configured, they must be routed to the other Dante devices on the audio network.
Dante Controller is required.
Ensure the control computer and NetPA AT are connected to the same network.
1.
From the start menu select All
2.
The Dante Controller - Network View screen opens.
Dante Controller auto-discovers Dante devices on the network and advertises itself to allow other Dante-enabled devices to
communicate with it. Device inputs are Dante receivers (listed vertically on the left) and device outputs are Dante transmitters
(listed horizontally across the top). Transmitters (outputs) connect to receivers (inputs) using the connection matrix.
Click the + box next to the NetPA (NetPA-Classroom-01) in the Dante Receivers column to show all device inputs.
3.
Click the + box next to the transmitter (DMP128-LectureHall) in the Dante Transmitter row to show all device outputs.
4.
> > Dante Controller > Dante Controller.
Product Category
7