Extron electronics NetPA AT Series Setup Manual page 4

NetPA AT Series • Setup Guide (Continued)
The Download Center page opens.
5 5
Download Center
Figure 3.
Fill in the required fields.
4.
Click Download dantecontrollernxn.exe.
5.
Save the file to your desktop (or other known location).
6.
Locate and double-click the saved Dante Controller file to begin installation.
7.
Follow the onscreen instructions. When the installation completes, close the installation dialog.
8.
Step 10 — Dante Network Setup
Rename the NetPA AT
Dante Controller auto-discovers all Dante devices on the network and advertises itself to allow other Dante-enabled devices to
communicate with it. The default device name is the word "NetPA" followed by the last six digits of the MAC address of the device.
Multiple devices on the same network can present difficulty identifying inputs and outputs. To avoid confusion, each device must
be renamed to a unique identifier.
NOTE:
To simplify renaming, connect only one Dante device to the network at a time. As each device is renamed, it can
remain connected.
Ensure the control computer and the NetPA AT are connected to the same network.
From the start menu select All Programs > Audinate > Dante
1.
Controller > Dante Controller .
The Dante Controller - Network View screen opens.
All Dante devices on the network are discovered and listed.
4
4 4
—
Dante Download