Lucent Technologies SLC-2000 User & Service Manual page 162

363-208-001
Operations and Maintenance Procedures (TOP)
Table 4-5. Numerical List of TOP Procedures (Continued)
Element Title
Detailed Level Procedures Tab Index
Contents Contents of This Tab
DLP-500 Perform Commands from the User Interface Panel
DLP-501 Install OHCTL Circuit Pack
DLP-502 Install or Replace BBG5 SYSCTL
DLP-503 Install TGS Circuit Packs
DLP-504 Install OLIU Plug-Ins with Optical Fibers Not Connected
DLP-505 Connect Optical Loop
DLP-506 Clean Optical Fibers, Connectors, and Lightguide Build-Outs
DLP-507 Perform LED Test
DLP-508 Perform Automatic Local Transmission Test
DLP-509 Test the SONET Feeder Protection Switching Function
DLP-510 Install DS1/DS1PM Low-Speed Interface Plug-Ins
DLP-511 Connect SLC
Optical Facility
DLP-512 Perform Automatic End-to-End OC-3 Line Test
DLP-513 Install New SONET Generic Program
DLP-514 Check 4A, 4B, and 4G Fan Unit Operation
DLP-515 Test Single-Party POTS Channel End to End
DLP-516 Perform Automatic DSX Transmission Test
DLP-517 Change Site ID, Network Element Address, Target Identification (TID), or
TBOS Display Number
DLP-518 Install or Replace the User Interface Display Panel
Connect SLC -2000 Access System to Ring Optical Facility
DLP-519
DLP-520 SONET Ring or Taper Cross-Connect Philosophy
DLP-521 Connect CIT and Establish Session (Releases 3.1, 3.2, and 3.3)
DLP-522 Establish Standard T1 Cross-Connections
DLP-523 Establish Standard T0 Cross-Connections
DLP-524 Install New DLC Generic Program
DLP-525 Connect CIT and Establish Session (Release 4.0 or Later)
DLP-526 Establish INA T1 Cross-Connections
DLP-527 Establish INA T0 Cross-Connections
DLP-528 Replace CORE Circuit Packs
DLP-529 Replace VTU/LIU Circuit Packs
DLP-530 Determine If Shelves or Assemblies Are Misaligned, Bowed, Bent, or
Twisted During Acceptance Testing
4-20 Issue 9 April 1998
®
-2000 Access System to Point-to-Point or Taper/Drop
Continued on next page