Lucent Technologies SLC-2000 User & Service Manual page 779

363-208-001
Issue 9, April 1998
26. Did the letter "C" appear in the FE ID display?
If NO, then proceed to Step 34.
If YES, then continue with Step 27.
Letter "C" in FE ID Display
27.
!
CAUTION:
If the system is in service and is forced to run the current software that is
displaying a C, service interruption may result.
NOTE:
Indications are that there may be a problem with the version of software
you are installing or you are trying to install a version of software that will
not support the current shelf provisioning. If you are downloading an
older version of software or upgrading to a new version of software which
has major changes or is incompatible with the version that you have, this
indication will occur. You can force the system to run the current software
or back out of this procedure by loading another version of software. You
must decide if you want the system to run this current version of software
that has been loaded or if you want to download another version (original
version or new version) of software.
Do you want to run the current version of software in the SYSCTL?
If NO, then continue with Step 28.
If YES, then proceed to Step 29.
28. Exit TERM (Alt-F2). Find new version of software and repeat this procedure
from Step 23.
29. To force the system to run the current software, perform the following:
a. Ensure that a TGS circuit pack is installed in the TGS-2 slot.
b. Remove the TGS-1 circuit pack.
c. Reset (unplug and reseat) the SYSCTL to force it to run the current
software.
d. After the current software is up and running (no alarm LEDs lighted or you
can log into the shelf), reinstall the TGS-1 circuit pack.
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
Detailed Level Procedures: DLP-538
Page 11 of 14