Programming
Introduction
1.4
Using the Password
To enter the programming mode, you must first enter the password Q*746*). If you have not made a programming
choice within a set amount of time, approximately three minutes, the system will automatically logoff. If logoff
occurs, you must re-enter the password.
1.5
Master Clearing the System
Before you begin any programming, you can master clear the system. Master clearing returns the entire system to
default conditions.
NOTE: Do not do this unless you want to clear all of the programming.
Returns entire system configuration to factory settings and clears all stored auto and speed dial nwnbers.
1.
Key in the password I*746* (this will get you into the main menu) and REIURN
2.
Press 1 for System C.O.S. and RETURN
3 . Press 1 for System Defaults and RETURN
4.
Press 8 for Master Clear System Data and RETURN
5 . PressytoconfmnandRETURN
6 . PressCTRLCtoreturntomainmenuandRETURN
4