ICP DAS USA GRP-2841M-5GE User Manual page 38

 Server IP:
 Server Port:
 Heartbeat Time:
 Device ID:
 Alias:
 Time Interval:
 Data Length:
 Modbus TCP to RTU: Modbus TCP to Modbus RTU gateway function.
 "Port1" = "COM1 (RS-232)"
 "Port2" = "COM2 (RS-485)"
 "Port3" = "COM3 (RS-485)"
 Default Baudrate:
 "115200" means baud rate is 115200 bps
 "57600" means baud rate is 57600 bps
 "38400" means baud rate is 38400 bps
 "19200" means baud rate is 19200 bps
 "9600"
 Default Format:
 Data bit support
 "8" means "8-bits"
 "7" means "7-bits"
 Parity bit support
 "N" means "None"
 "O" means "Odd"
 "E" means "Even"
 Stop bit support
 "2" means "2-bits"
 "1" means "1-bit"
 Enable Function:
 [1] VxServer will detect the disconnection in advance and terminate the connection.
 [2] If the time interval between two serial data is greater than this value, the data will be
divided into two network packets. If there is not enough time interval, but the data
length exceeds the "Data Length", the data is still divided into two network packets.
GRP-2841M-5GE User Manual
Copyright © 2022 ICP DAS Co., Ltd. All Rights Reserved
VxServer IP or domain name.
VxServer port number.
The time interval for sending heartbeat packets to VxServer.
The unique ID used to identify the device.
The alias of the device. The maximum length is 8 characters.
The time interval for sending serial port data to VxServer.
The data length of the serial port data sent to the VxServer.
This value depends on your serial device.
means baud rate is 9600 bps
The configuration of "data bit", "parity" and "stop bit".
Whether to Enable this function. This setting will run after reboot.
Version 1.1.0
E-mail: service@icpdas.com
[1]
[2]
[3]
38
Page：