Table of Contents
Advertisement
7
SPECIFICATIONS
NOTE
1. Use 1:1 with an inverter. Do not connect more than one inverter to one power
regenerative unit.
2. Use the power regenerative unit whose capacity is equal to one exceeding
the inverter capacity to be combined.
3. Do not use this unit with single-phase power. Use three-phase power.
Table 17
Model CIMR-R5Uj
Rated Capacity
kW
Rated DC Current
Rated Current on
Power Side
Regenerative Torque
Voltage Frequency
Allowable Voltage
Fluctuation
Allowable Frequency
Fluctuation
Control Method
Input Power Factor
Overload Capacity
Operation Input
Fault
Running, READY
Signal
Analog Output
Instantaneous
Overcurrent
Blown Fuse
Overload
Undervoltage
(DC Voltage)
Undervoltage
(Power Side Voltage)
Overload
Fin Overheat
Power Supply Open
Phase
Power Frequency Error
Power Charge
Indication
200 V Class Specifications
23P7
3.7
A
13
10
A
25P5
27P5
2011
2015
5.5
7.5
11
15
19
26
37
51
15
20
30
40
100 % for 1 minute, 25 % ED, 80 % continuous
200 to 220 VAC 50 Hz, 200 to 230 VAC 60 Hz
+10 to −15 % (Imbalance rate between phases: within 2 %)
¦3 Hz (Free phase rotation)
120° current conduction
0.9 or more (Rated current)
Stops in 30 seconds at approx. 150 % of rated current.
External terminals
1C contact output
Photocoupler output
Analog output: 1 point can be selected (current monitor)
Stops at approx. 200 % of the current on power side
Motor stops by blown fuse.
Stops after 30 seconds at 150 % of rated current
Stops at approx. 190 VDC or less.
Stops at approx. 150 VAC or less.
Stops at approx. 400 VDC or more.
Protected by thermister
Stops at power supply open phase detection.
Stops by fluctuation more than ± 3 Hz of rated input frequency.
Indicated until main output voltage is approx. 50 V or less.
7
SPECIFICATIONS
2018
2022
2030
2037
18.5
22
30
37
64
77
102
126
50
60
80
100
47
Advertisement
Table of Contents
