Honeywell UDC2800 Product Manual page 102

Chapter 6 - Input Calibration
Table 6-4: Set Up Wiring Procedure for RTD Inputs
Step
1
102
RTD Inputs
Refer to Input 1 Set up Wiring - and wire the controller according to
the procedure given in Set Up Wiring Procedure for RTD Inputs.
Action
Connect the copper leads from the calibrator to the Input #1
terminals as shown in figure Input 1 Set up Wiring .
Figure 6-3: Wiring Connections for RTD (Resistance Thermometer
Device)
Millivolts, Volts or Thermocouple Differential Inputs
See the following figure and wire the controller according to the
procedure given in the following table.