Status Tests
Introduction
When required, the results of these tests can be checked to
determine the reason the controller has gone to Failsafe.
How to check the status tests
The procedure in table below tells you how to display the results of
the status tests.
Table 8-2: Procedure for Displaying the Status Test Results
Step
Operation
1
Select
Status set
up group
2
Read the
test results
Press
Result
Setup key
Until you see Status.
Function key
Enter into the first function prompt Software
Version of the Status set up group.
Increment key
Until you see Failsafe Status. You can see the
or Decrement
Failsafe status, No or Yes. Yes, indicates a
key
failure.
Increment key
Until you see Self Tests. You can see the status
or Decrement
of Self Tests, Pass or Fail.
key
Chapter 8 - Troubleshooting/Service
121