Ce Conformity (Europe) - Honeywell UDC2800 Product Manual

Chapter 2 - Introduction
Bluetooth communications
The Bluetooth connection provides a non-intrusive wireless
connection with the instrument and maintains NEMA4X and IP66
integrity.
No need to get access to the back of the controller to communicate
with the instrument, no need to take your screwdriver to wire the
communication cable, no wiring mistake possible. You can now
duplicate an instrument's configuration upload, or download a new
configuration in a matter of seconds, just by connecting your mobile
device to instrument through Bluetooth.
: It takes less than 2 seconds to upload configuration
Connect & Upload
from an instrument. You can then save the configuration file onto
your mobile device for review modification, or archiving.
Furthermore, the software and app also give you important
maintenance information on the controller: instantly, get information
on the current operating parameters, digital inputs, and alarm status,
identify internal or analog input problems.
: What if I have several controllers on the same panel? How
Questions
can I be sure I am communicating with the correct one?
: The UDC device's Bluetooth ID appears in the
Answer
communications group on the controller screen, each controller is
assigned with different Bluetooth ID's, user can identify same
Bluetooth ID in the menu under the device list and connect to the
controller.

CE Conformity (Europe)

This product is in conformity with the protection requirements of the
following European Council Directives: 2014/35/EU, the Low Voltage
Directive, and 2014/30/EU, the EMC Directive. Conformity of this
product with any other "CE Mark" Directive(s) shall not be assumed.
Product Classification: Class I: Permanently connected, panel-
mounted Industrial Control Equipment with protective earthing
(grounding) (EN61010-1).
Enclosure Rating: This controller must be panel-mounted with the
rear terminals enclosed within the panel. The front panel of the
controller is rated at NEMA4X and IP66 when properly installed.
Installation Category (Overvoltage Category): Category II (EN61010-
1)
20