Table of Contents
Advertisement
Chapter 5 - Operating the Limit Controller
Step
Operation
2
Select the
Alarm
Setpoint
Values
3
Change a
value
4
Enter the
value
5
Return to
Normal
Display
94
Press
Result
Function key
Enter in the first function prompt A1S1 Type.
Increment key or
Until you see the required Alarm setpoint.
Decrement key
A1S1 Value = Alarm 1, Setpoint 1 Value
A1S2 Value = Alarm 1, Setpoint 2 Value
A2S1 Value = Alarm 2, Setpoint 1 Value
A2S2 Value = Alarm 2, Setpoint 2 Value
To successively display the alarm setpoints
and their values. Their order of appearance is
shown below.
Lower Display = (the alarm setpoint value)
Range values are within the range of the
selected parameters except:
Deviation value = Configurable from 0 to 9999
PV Rate of Change = The amount of PV
change in one minute in engineering units.
Loop Break Alarms (Loop Break) = The timer
value may be changed only for controllers
configured for ON/OFF control.
Function key
Enter in the first selection of the selected
Alarm Setpoint
Increment key or
Change any alarm setpoint value.
Decrement key
Function key
Enter the value made into memory.
Lower Display
Exit the set up mode and returns to the main
key
screen.
NOTE: TC warning, TC Fail and Failsafe
selections do not have setpoint values.
Advertisement
Table of Contents
Troubleshooting
