Defining Dynamic Addresses - NETGEAR ProSafe FS728TP Software User Manual

Defining Dynamic Addresses

The Dynamic Addresses Page contains parameters for querying information in the Dynamic MAC
Address Table, including the interface type, MAC addresses, VLAN, and table storing. The
Dynamic MAC Address table contains information about the aging time before a dynamic MAC
address is erased and includes parameters for querying and viewing the Dynamic MAC Address
table. The Dynamic MAC Address table contains address parameters by which packets are directly
forwarded to the ports. Interface, VLAN, and MAC Address can sort the Dynamic Address Table.
To configure the Dynamic MAC Address Table:
1. Click System >Address Table > Dynamic Addresses. The Dynamic Addresses Page opens:
Figure 5-54
The Dynamic Addresses Page contains the following fields:
– Address Aging – Specifies the amount of time the MAC address remains in the Dynamic
MAC Address table before it is time out if no traffic from the source is detected. The
default value is 300 seconds.
– Clear Table – Removes the current values from the table.
Configuring the Device Using Your Browser
FS728TP Smart Switch Software User Manual
v2.0, November 2006
5-80