Configuring Lacp - NETGEAR ProSafe FS728TP Software User Manual

FS728TP Smart Switch Software User Manual

Configuring LACP

LAG ports can contain different media types if the ports are operating at the same speed.
Aggregated links can be set up manually or automatically established by enabling LACP on the
relevant links. Aggregate ports can be linked into link-aggregation port-groups. Each group is
comprised of ports with the same speed. The LACP Page contains fields for configuring LACP
LAGs. To configure LACP for LAGs:
1. Click Switch > LAG Configuration > LACP Page. The LACP Page opens:
Figure 5-45
The LACP Page contains the following fields:
– LACP System Priority – Specifies system priority value. The field range is 1-65535. The
field default is 1.
– Interface – Displays the interface for which the LAG parameters are defined.
– Interface Priority – Displays the LACP priority value for the port. The field range is 1-
65535.
– LACP Timeout – Displays the administrative LACP timeout.
5-67 Configuring the Device Using Your Browser
v2.0, November 2006